Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: error fpga fan speed
Luckily my 6300 fan failed within warranty, Flex honoured all costs for it to be fixed so no beef there, however the cooling arrangement used (IMO) is something I would expect to see on a Xilinx deve…1 -
Re: error fpga fan speed
Bill, I wish that were true, my limited edition 6500 fan and heatsink arrangement simply "fell off" and had to be "stuck on" again. Hence my comments here from experience.1 -
Re: error fpga fan speed
I took some measurements when I was in there. The rf screen box is 20mm high the heatsink is 50mmx50mmx8mm and hovers over the pcb by about 4mm. So there is approximately 8mm gap between the top of t…1 -
Re: So how badly did you want those fuzzy looking analog meters on a 7610?
Save compute power for something else other than pretty meters.1 -
Re: Rx audio does not mute during transmit in CW mode.
This has always been a problem for me Bob and a year later it is still broken in my opinion. it has taken me a while to realise what is going on. Full and semi break-in modes work fine, but when brea…1
